Elliptic filter

Elliptic filter

An elliptic filter (also known as a Cauer filter, named after Wilhelm Cauer) is an electronic filter with equalized ripple (equiripple) behavior in both the passband and the stopband. The amount of ripple in each band is independently adjustable, and no other filter of equal order can have a faster transition in gain between the passband and the stopband, for the given values of ripple (whether the ripple is equalized or not). Alternatively, one may give up the ability to independently adjust the passband and stopband ripple, and instead design a filter which is maximally insensitive to component variations.

As the ripple in the stopband approaches zero, the filter becomes a type I Chebyshev filter. As the ripple in the passband approaches zero, the filter becomes a type II Chebyshev filter and finally, as both ripple values approach zero, the filter becomes a Butterworth filter.

The gain of a lowpass elliptic filter as a function of angular frequency ω is given by:

:G_n(omega) = {1 over sqrt{1 + epsilon^2 R_n^2(xi,omega/omega_0)

where Rn is the "n"th-order elliptic rational function (sometimes known as a Chebyshev rational function) and

:omega_0 is the cutoff frequency :epsilon is the ripple factor :xi is the selectivity factor

The value of the ripple factor specifies the passband ripple, while the combination of the ripple factor and the selectivity factor specify the stopband ripple.

Properties

* In the passband, the elliptic rational function varies between zero and unity. The passband of the gain therefore will vary between 1 and 1/sqrt{1+epsilon^2}.

* In the stopband, the elliptic rational function varies between infinity and the discrimination factor L_n which is defined as:

:L_n=R_n(xi,xi),

:The gain of the stopband therefore will vary between 0 and 1/sqrt{1+epsilon^2L_n^2}.

* In the limit of xi ightarrow infty the elliptic rational function becomes a Chebyshev polynomial, and therefore the filter becomes a Chebyshev type I filter, with ripple factor ε

* Since the Butterworth filter is a limiting form of the Chebyshev filter, it follows that in the limit of xi ightarrow infty, omega_0 ightarrow 0 and epsilon ightarrow 0 such that epsilon,R_n(xi,1/omega_0)=1 the filter becomes a Butterworth filter

* In the limit of xi ightarrow infty, epsilon ightarrow 0 and omega_0 ightarrow 0 such that xiomega_0=1 and epsilon L_n=alpha, the filter becomes a Chebyshev type II filter with gain

::G(omega)=frac{1}{sqrt{1+frac{1}{alpha^2 T^2_n(1/omega)}

Poles and zeroes

The zeroes of the gain of an elliptic filter will coincide with the poles of the elliptic rational function, which are derived in the article on elliptic rational functions.

The poles of the gain of an elliptic filter may be derived in a manner very similar to the derivation of the poles of the gain of a type I Chebyshev filter. For simplicity, assume that the cutoff frequency is equal to unity. The poles (omega_{pm}) of the gain of the elliptical filter will be the zeroes of the denominator of the gain. Using the complex frequency s=sigma+jomega this means that:

:1+epsilon^2R_n^2(-js,xi)=0,

Defining -js=mathrm{cd}(w,1/xi) where cd() is the Jacobi elliptic cosine function and using the definition of the elliptic rational functions yields:

:1+epsilon^2mathrm{cd}^2left(frac{nwK_n}{K},frac{1}{L_n} ight)=0,

where K=K(1/xi) and K_n=K(1/L_n). Solving for "w"

:w=frac{K}{nK_n}mathrm{cd}^{-1}left(frac{pm j}{epsilon},frac{1}{L_n} ight)+frac{mK}{n}

where the multiple values of the inverse cd() function are made explicit using the integer index "m".

The poles of the elliptic gain function are then:

:s_{pm}=i,mathrm{cd}(w,1/xi),

As is the case for the Chebyshev polynomials, this may be expressed in explicitly complex form ref_harvard|Lutovac|Lutovac 2001 § 12.8|

:s_{pm}=frac{a+jb}{c}

:a=-zeta_nsqrt{1-zeta_n^2}sqrt{1-x_m^2}sqrt{1-x_m^2/xi^2}

:b=x_msqrt{1-zeta_n^2(1-1/xi^2)}

:c=1-zeta_n^2+x_i^2zeta_n^2/xi^2

where zeta_n is a function of n,,epsilon and xi and x_m are the zeroes of the elliptic rational function. zeta_n is expressible for all "n" in terms of Jacobi elliptic functions, or algebraically for some orders, especially orders 1,2, and 3. For orders 1 and 2 we have

:zeta_1=frac{1}{sqrt{1+epsilon^2

:zeta_2=frac{2}{(1+t)sqrt{1+epsilon^2}+sqrt{(1-t)^2+epsilon^2(1+t)^2

where

:t=sqrt{1-1/xi^2}

The algebraic expression for zeta_3 is rather involved (See ref_harvard|Lutovac|Lutovac 2001 § 12.8.1|).

The nesting property of the elliptic rational functions can be used to build up higher order expressions for zeta_n:

:zeta_{mcdot n}(xi,epsilon)=zeta_mleft(xi,sqrt{frac{1}{zeta_n^2(L_m,epsilon)}-1} ight)

where L_m=R_m(xi,xi).

Minimum Q-factor elliptic filters


300px|thumb|right">
The normalized Q-factors of the poles of an 8-th order elliptic filter with ξ=1.1 as a function of ripple factor ε. Each curve represents four poles, since complex conjugate pole pairs and positive-negative pole pairs have the same Q-factor. (The blue and cyan curves nearly coincide). The Q-factor of all poles are simultaneously minimized at εQmin=1/√Ln=0.02323...

See ref_harvard|Lutovac|Lutovac 2001 § 12.11| and

Elliptic filters are generally specified by requiring a particular value for the passband ripple, stopband ripple and the sharpness of the cutoff. This will generally specify a minimum value of the filter order which must be used. Another design consideration is the sensitivity of the gain function to the values of the electronic components used to build the filter. This sensitivity is inversely proportional to the quality factor (Q-factor) of the poles of the transfer function of the filter. The Q-factor of a pole is defined as:

:Q =-frac{2mathrm{Re} (s_{pm})} = -frac{1}{2cos(arg(s_{pm}))}

and is a measure of the influence of the pole on the gain function. For an elliptic filter, it happens that, for a given order, there exists a relationship between the ripple factor and selectivity factor which simultaneously minimizes the Q-factor of all poles in the transfer function:

:epsilon_{Qmin}=frac{1}{sqrt{L_n(xi)

This results in a filter which is maximally insensitive to component variations, but the ability to independently specify the passband and stopband ripples will be lost. For such filters, as the order increases, the ripple in both bands will decrease and the rate of cutoff will increase. If one decides to use a minimum-Q elliptic filter in order to achieve a particular minimum ripple in the filter bands along with a particular rate of cutoff, the order needed will generally be greater than the order one would otherwise need without the minimum-Q restriction. An image of the absolute value of the gain will look very much like the image in the previous section, except that the poles are arranged in a circle rather than an ellipse. They will not be evenly spaced and there will be zeroes on the ω axis, unlike the Butterworth filter, whose poles are also arranged in a circle.

Comparison with other linear filters

Here is an image showing the elliptic filter next to other common kind of filters obtained with the same number of coefficients:

As is clear from the image, elliptic filters are sharper than all the others, but they show ripples on the whole bandwidth.

References

*note_label|Daniels|Daniels 1974|cite book |last=Daniels |first=Richard W. |authorlink= |coauthors= |title=Approximation Methods for Electronic Filter Design |year=1974 |publisher=McGraw-Hill |location=New York |id=ISBN 0-07-015308-6

*cite book |last=Lutovac |first=Miroslav D. |coauthors= Tosic, Dejan V., Evans, Brian L. |title=Filter Design for Signal Processing using MATLAB© and Mathematica© |year=2001 |publisher=Prentice Hall |location=New Jersey, USA |language=English |id=ISBN 0-201-36130-2


Wikimedia Foundation. 2010.

Игры ⚽ Нужен реферат?

Look at other dictionaries:

  • Elliptic rational functions — In mathematics the elliptic rational functions are a sequence of rational functions with real coefficients. Elliptic rational functions are extensively used in the design of elliptic electronic filters. (These functions are sometimes called… …   Wikipedia

  • Chebyshev filter — Linear analog electronic filters Network synthesis filters Butterworth filter Chebyshev filter Elliptic (Cauer) filter Bessel filter Gaussian filter Optimum L (Legendre) filter Linkwitz Riley filter …   Wikipedia

  • Electronic filter — Electronic filters are electronic circuits which perform signal processing functions, specifically intended to remove unwanted signal components and/or enhance wanted ones. Electronic filters can be:*passive or active *analog or digital *discrete …   Wikipedia

  • Butterworth filter — The Butterworth filter is one type of electronic filter design. It is designed to have a frequency response which is as flat as mathematically possible in the passband. Another name for them is maximally flat magnitude filters.The Butterworth… …   Wikipedia

  • Optimum "L" filter — Linear analog electronic filters Network synthesis filters Butterworth filter Chebyshev filter Elliptic (Cauer) filter Bessel filter Gaussian filter Optimum L (Legendre) filter Linkwitz Riley filter …   Wikipedia

  • Active filter — An active filter is a type of analog electronic filter, distinguished by the use of one or more active components i.e. voltage amplifiers or buffer amplifiers. Typically this will be a vacuum tube, transistor or operational amplifier.Active… …   Wikipedia

  • Gaussian filter — In electronics and signal processing, a Gaussian filter is a filter whose filter window is the Gaussian function:x mapsto sqrt{frac{a}{picdot e^{ a cdot x^2}or with the standard deviation as parameter:x mapsto frac{1}{sqrt{2cdotpi}cdotsigma}cdot… …   Wikipedia

  • Bessel filter — In electronics and signal processing, a Bessel filter is a variety of linear filter with a maximally flat group delay (linear phase response). Bessel filters are often used in audio crossover systems. Analog Bessel filters are characterized by… …   Wikipedia

  • Linear filter — A linear filter applies a linear operator to a time varying input signal. Linear filters are very common in electronics and digital signal processing (see the article on electronic filters), but they can also be found in mechanical engineering… …   Wikipedia

  • Composite image filter — Linear analog electronic filters Network synthesis filters Butterworth filter Chebyshev filter Elliptic (Cauer) filter Bessel filter Gaussian filter Optimum L (Legendre) filter Linkwitz Riley filter …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”